Dear MAGNAT Customer,
Congratulations on your ne new loudspeakers and thank you very much for choosing MAGNAT! You
have made an excellent choice. The high-quality speakers produced by MAGNAT are renowned all over
the world.
Please study the instructions and information below carefully before using your new loudspeakers.
FITTING THE FEET (SIGNATURE 507 AND SIGNATURE 505 ONLY)
The (2) feet included in the delivery package must be tted to the loudspeaker before use. To do this,
place the speakers on a clean, stable base with the bottom facing upwards. It is better not to remove
the protective bag until after tting has been completed so as to avoid damage to the surface.
Now t the two pre-assembled feet using the M6 screws provided, as shown in Fig. 1.
GENERAL INFORMATION ABOUT CONNECTING YOUR MAGNAT SIGNATURE 500 LOUDSPEAKERS
Please always use a good quality loudspeaker connection cable from an audio dealer. To prevent
impairment of sound quality, we recommend cables with cross-sections of at least 2.5 mm² for lengths up
to 3 m and at least 4 mm² for lengths above 3 m.
Always turn off the amplier or receiver before connecting or disconnecting loudspeaker cables. Place
the loudspeakers in their planned positions and cut the cables to the right length. The cables for both
channels should always be exactly the same length.
Strip 10 – 15 mm of insulation from the ends of the cables. Twist the ends – this is much better than tinning
them with solder – insert them in the terminals and tighten the terminal screws rmly. (Fig. 2)
For good sound it is imperative that the cables must be connected in such a way that the speakers are
“in phase”. This means that the black negative terminals on the speakers (-) must be connected to the
negative (-) terminals on the amplier, the red positive (+) speaker terminals to the positive (+) amplier
terminals. To make this easier one wire of most speaker cables is marked with a coloured strip or a ridge
in the insulation.
Before switching on the system double-check all your connections and make sure that the terminal screws
are tight and that there are no short circuits caused by stray wire laments – this could cause serious
damage to your amplier!
THE MAGNAT SIGNATURE 500 LOUDSPEAKERS IN STEREO MODE
In the ideal conguration the speakers and the listening position should form an equilateral triangle. When
the left and right speakers are the same distance from the listening position their sound arrives at the
same time, resulting in a harmonious, natural music reproduction. (Fig. 3)
There should be a clear line of sight between the loudspeakers and the listening position. Any sound-
absorbing or reecting obstacles in the path will distort the sound. When you install the loudspeakers the
following distances should be maintained:
SIGNATURE 500 oorstanders: at least 20 cm away from the rear wall and at least 30 cm from the side
walls. This will prevent excessive emphasis of the bass range.
SIGNATURE 500 bookshelf speakers: shelf loudspeakers should also be as free-standing as possible,
the distance to the sides and rear to walls and items should be at least 10 cm, the tweeters should be
located at ear height.
Spikes (SIGNATURE 500 oorstanders): you should use the supplied spikes when setting the speakers
up. This isolates them from the supporting surface, preventing unpleasant resonance effects. You can
choose between metal and hard rubber spikes for the standing speakers. The spikes are screwed into
the threaded sleeves in the feet from below and tightened from above with the locking nut.
7
この商品に関する会話に参加する
ここでは、Magnat Signature 505 スピーカー についての意見を共有できます。 疑問がある場合は、まず説明書をよく読んでください。 マニュアルのご請求は、お問い合わせフォームより承ります。