説明書 フィリップス NT1650 鼻毛トリマー

説明書

Warning

- This appliance can be used by children aged

from 8 years and above and persons with

reduced physical, sensory or mental capabilities

or lack of experience and knowledge if they

have been given supervision or instruction

concerning use of the appliance in a safe way

and understand the hazards involved. Children

shall not play with the appliance. Cleaning

and user maintenance shall not be made by

children without supervision.

- Always check the appliance before you use

it. Do not use the appliance if it is damaged,

as this may cause injury. Always replace a

damaged part with one of the original type.

Caution

- Never immerse the appliance in water. Do not

use the appliance in the bath or shower.

- Never use water hotter than 60 °C to rinse the

appliance.

- Only use this appliance for its intended purpose

as shown in the user manual.

- Use and store the appliance at a temperature

between 15 °C and 35 °C.

- For hygienic reasons, the appliance should only

be used by one person.

- Do not expose the appliance to direct sunlight.

- Only operate the appliance on 1.5V AA alkaline

batteries.

- Do not recharge non-rechargeable batteries.

- Insert batteries with the + and - poles pointing

in the direction indicated in the battery

compartment or holder.

- Do not short-circuit the supply terminals of

batteries.

- Remove batteries from the appliance if you are

not going to use it for some time.

- Never use compressed air, scouring pads,

abrasive cleaning agents or aggressive

liquids such as petrol or acetone to clean the

appliance.

Electromagnetic elds (EMF)

This Philips appliance complies with all applicable

standards and regulations regarding exposure to

electromagnetic elds.

General

- This appliance can be safely cleaned under the

tap.

Introduction

Congratulations on your purchase and welcome

to Philips! To fully benet from the support that

Philips oers, register your product at www.philips.

com/welcome.

General description (Fig. 1)

1 Cutting element

2 Trimming head

3 Handle

4 ‚Unlocked‘ indication

5 Locking indicator

6 ‚Locked‘ indication

7 Setting indicator

8 ‚On‘ indication

9 ‚O‘ indication

10 ‚Open‘ indication

11 Battery compartment cover

12 1 “AA” battery

13 Cleaning brush

Preparing for use

Placing the battery

Note: Make sure your hands and appliance are dry

when inserting the battery.

1 To remove the battery compartment cover,

turn it until the setting indicator points to the

‚unlocked‘ indication (^) (Fig. 2)

2 Pull the battery compartment cover o the

handle (Fig. 3).

3 Put the battery in the battery compartment

(Fig. 4).

Make sure the + and - poles of the battery

point in the right direction.

Note: The appliance operates on one

replaceable AA 1.5-volt battery (included).

4 Slide the battery compartment cover back onto

the handle (Fig. 5).

5 Turn the battery compartment cover until the

setting indicator points to the ‚o’ indication

(0). (Fig. 6)

Using the appliance

Switching the appliance on and o

1 To switch on the product, turn the battery

compartment cover until the setting indicator

aligns with the ‚on‘ indication (I) (Fig. 7).

2 To switch o the product, turn the battery

compartment cover until the setting indicator

aligns with the ‚o‘ indication (0) (Fig. 8).

Detaching and attaching the attachments

Note: Switch o the appliance before detaching or

attaching the attachments.

1 To detach the trimming head from the handle,

rmly grasp the attachment below the cutting

element and turn it until the locking indicator

points to the ‚unlocked‘ indication (^).

2 Lift the trimming head o of the handle.

1 To attach the trimming head to the handle,

place the attachment on the handle with the

setting indicator pointing to the ‚unlocked‘

indication (^).

2 Firmly grap the attachment below the cutting

element and turn it until the locking indicator

points to the ‚locked‘ indication (0).

Tip: If the trimming head becomes clogged, detach

the attachment and rinse it thoroughly with warm

water before you reattach it.

Trimming ear hair

Make sure your outer ear channels are clean and

free from wax.

1 Switch on the appliance.

2 Slowly move the trimming head along the rim of

the ear to remove hairs that stick out beyond

the rim.

Do not insert the trimming head more than 5 mm

(13/64 in) into your ear channel, as this could

damage the eardrum.

1 Carefully insert the trimming head into the outer

ear channel.

2 Slowly turn the trimming head around to

remove all unwanted hairs from your outer ear

channel (Fig. 9).

3 Clean thoroughly after each use (see ‚Cleaning‘).

Trimming nose hair

Make sure both the appliance and nasal passages

are clean before trimming. Dried nasal mucus

can block the cutting element, preventing the

appliance from turning on.

1 Switch on the appliance.

2 Slowly move the trimming head along the rim

of the nostril to remove hairs that stick out

beyond the rim.

3 Carefully insert the trimming head into one of

your nostrils.

Do not insert the trimming head more than

5 mm (13/64 in) into your nostrils.

4 Slowly move the trimming head around inside

each nostril (Fig. 10), making sure the at side

of the trimmer is held rmly against the skin.

(Fig. 11) This will reduce the tickling eect that

can occur.

5 Clean thoroughly after each use (see ‚Cleaning‘).

Cleaning

Cleaning the trimming head

Do not immerse the motor unit in water or any

other liquid.

Never use scouring pads, abrasive cleaning agents

or aggressive liquids such as gasoline or acetone

to clean the appliance or any attachments or

accessories.

Do not tap on the cutting elements.

Do not use any sharp objects to clean the cutting

elements.

Clean the trimming head immediately after use

and when a lot of hair or dirt has accumulated on

the cutting elements.

1 Use the cleaning brush to remove any excess

hair from the cutting element. (Fig. 12)

2 Rinse the cutting element of the trimming head

with hot water (Fig. 13).

3 Switch on the appliance and rinse the cutting

element and trimming head again to remove

any remaining hairs. Switch o the appliance.

Tip: If rinsing the trimming head under the tap

is not sucient, immerse the trimming head in

a glass with warm water for a few minutes (Fig.

14). Then switch on the appliance and rinse it

under the tap.

4 Carefully shake o excess water and let all parts

air dry.

Storage

Store the appliance in a safe, dry location. Ensure

that the appliance and accessories are completely

dry before storage.

Recycling

- Do not throw away the product with the

normal household waste at the end of its life,

but hand it in at an ocial collection point for

recycling. By doing this, you help to preserve

the environment.

- This product contains disposable batteries

which shall not be disposed of with normal

household waste.

- Follow your country‘s rules for the separate

collection of electrical and electronic products

and batteries. Correct disposal helps prevent

negative consequences for the environment

and human health.

Removing the disposable batteries

To remove the disposable batteries, see chapter

‚Preparing for use‘.

Warranty and support

If you need information or support, please

visit www.philips.com/support or read the

international warranty leaet.

Warranty restrictions

Cutting units are not covered by the terms of the

international warranty because they are subject to

wear.

ENGLISH NT1650/16

1

AA

1

9

10

3

11

7

8

2

12 13

6 5 4

2 min.

Max.

2

3

4

5

6

13

12

11

10

9

8

7

14

AA

6

評価

このマニュアルの詳細

フィリップス NT1650 鼻毛トリマー に紙のマニュアルがあると便利だと理解しています。 マニュアルは当社 Web サイトからいつでもダウンロードして、ご自身で印刷していただけます。 オリジナルのマニュアルが必要な場合は、Philips にお問い合わせいただくことをお勧めします。 オリジナルのマニュアルを提供してくれるかもしれません。 フィリップス NT1650 鼻毛トリマー の別の言語のマニュアルをお探しですか? 当社のホームページでご希望の言語を選択し、モデル番号を検索して入手可能かどうかを確認してください。

仕様

フィリップス 鼻毛トリマー のすべてのマニュアル
鼻毛トリマー のその他のマニュアル

フィリップス NT1650 鼻毛トリマー に関するよくある質問

当社のサポートチームは有用な製品情報とよくある質問への回答を検索します。よくある質問に誤りがある場合は、お問い合わせフォームを介してお知らせください。