説明書 カシオ Edifice EF-527D-1AVEF 時計

カシオ Edifice EF-527D-1AVEF 時計 のマニュアルが必要ですか? 以下では、日本語の PDF マニュアルを無料で表示およびダウンロードできます。 この製品には現在、7 件のよくある質問、0 件のコメントがあり、0 件の投票があります。 これがご希望のマニュアルではない場合は、お問い合わせください。

ご利用の製品に欠陥があり、マニュアルでは解決出来ない問題ですか。無料の修理サービスを行うRepair Café (Repair Café) に移動します。

説明書

Loading…

Operation Guide ANA(ST5)V.A
2
Hour hand
First click
(Setting day)
Second click
(Setting time)
Crown
(Normal position)
Day
Second hand
Minute hand
Setting the Time and
Day
To set the time
1. Pull the crown out to the second click.
At this time, the second hand will move to the
12 o’clock position and stop there.
2. Set the hands by rotating the crown. Rotate the
crown to move the hands clockwise. Move the
minute hand four or five minutes past the time
you want to set, and then back it up to the
proper setting.
Carefully set the time, making sure to
distinguish between AM and PM.
3. Push the crown back in to the normal position
to restart timekeeping.
To set the day
1. Pull the crown out to the first click.
2. Set the day by rotating the crown towards you.
3. Push the crown back in to the normal position.
Avoid changing the date setting while the
current time is between 9:00 p.m. and 1:00 a.m.
Some water resistant models are equipped
with a screw lock crown.
With such models, you must unscrew the
crown in the direction noted in the
illustration to loosen it before you can pull it
out. Do not pull too forcibly on such crowns.
Also note that such watches are not water
resistant while their crowns are loosened.
Be sure to screw the crowns back in as far
as they will go after making any setting.
The watch attached with a bezel can
measure the elapsed time. Align the
mark on the bezel with the minute hand
by turning it so that the time elapsed from
the mark can be measured.
Elapsed
time
Start
Using the Stopwatch
Stopwatch hour hand
Stopwatch 1/20 second
hand
* This hand rotates and
indicates the 1/20 second
count durin
g
the first 30 seconds.
Stopwatch minute hand
Stopwatch second hand
The stopwatch lets you measure elapsed time up
to 11 hours, 59 minutes, 59.95 seconds.
To measure elapsed time
1. Press A to start the stopwatch.
2. Press A to stop the stopwatch.
You can resume the measurement operation
by pressing A again.
The stopwatch 1/20 second hand rotates and
indicates the 1/20 second count during the
first 30 seconds.
3. Check the elapsed time.
The example below shows an elapsed time of
two minutes, 18.80 seconds.
Stopwatch 1/20 second
hand [80]
Stopwatch minute hand
[2 minutes]
Stopwatch second hand
[18 seconds]
Press B to reset the stopwatch.
This will enter the Timekeeping Mode.
To return the function of the stopwatch 1/20
second hand to the timekeeping seconds
hand (indicating the current seconds count),
press B again.
Notes:
Do not try to perform stopwatch operations
while the crown is pulled out either to the first or
second click. If you try to press a button, you
might accidentally cause the crown to rotate and
change the current time or day setting.
If the starting positions of the stopwatch second
hand and 1/20 second hand become mis-
aligned, use the following procedures to adjust
the positions of the hands so they point to 12
o’clock when the stopwatch is reset.
To adjust the positions of the stopwatch
hands
1. Press B to reset the stopwatch, and check the
alignment of the stopwatch second hand and
1/20 second hand.
2. Pull out the crown to the second click.
3. Press A to move the stopwatch second hand.
Holding down A will start high-speed
movement of the stopwatch second hand.
4. Press B.
5. If the stopwatch 1/20 second hand is aligned
correctly, proceed to step 6. If the stopwatch
1/20 second hand is also misaligned, press B
to move the stopwatch 1/20 second hand.
Holding down B will start high-speed
movement of the stopwatch 1/20 second
hand.
6. After making the adjustments you want, push
the crown back in to its normal position.
Note that pulling the crown out also stops the
timekeeping second hand. After performing the
above procedure, you should also adjust the
timekeeping setting.
説明書を日本語でタウンロード (PDF, 0.97 MB)
(環境を考慮し、本当に必要な場合にのみこのマニュアルを印刷します)

Loading…

評価

カシオ Edifice EF-527D-1AVEF 時計について、製品の評価を入力し、お客様のお考えをお教えてください。この製品とのお客様の経験を共有したいですか、または質問したいですか。ページ下部にコメントを入力してください。
カシオ Edifice EF-527D-1AVEF 時計 に満足していますか?
はい いいえ
この商品を最初に評価する
0 投票

この商品に関する会話に参加する

ここでは、カシオ Edifice EF-527D-1AVEF 時計 についての意見を共有できます。 疑問がある場合は、まず説明書をよく読んでください。 マニュアルのご請求は、お問い合わせフォームより承ります。

このマニュアルの詳細

カシオ Edifice EF-527D-1AVEF 時計 に紙のマニュアルがあると便利だと理解しています。 マニュアルは当社 Web サイトからいつでもダウンロードして、ご自身で印刷していただけます。 オリジナルのマニュアルが必要な場合は、Casio にお問い合わせいただくことをお勧めします。 オリジナルのマニュアルを提供してくれるかもしれません。 カシオ Edifice EF-527D-1AVEF 時計 の別の言語のマニュアルをお探しですか? 当社のホームページでご希望の言語を選択し、モデル番号を検索して入手可能かどうかを確認してください。

仕様

メーカー Casio
モデル Edifice EF-527D-1AVEF
カテゴリー 時計
ファイルの種類 PDF
ファイルサイズ 0.97 MB

カシオ 時計 のすべてのマニュアル
時計 のその他のマニュアル

カシオ Edifice EF-527D-1AVEF 時計 に関するよくある質問

当社のサポートチームは有用な製品情報とよくある質問への回答を検索します。よくある質問に誤りがある場合は、お問い合わせフォームを介してお知らせください。

デバイスのバッテリーが酸化されていますが、それでも安全に使用できますか? 確認済み

Ja、デバイスはまだ安全に使用できます。まず、酸化電池を取り外します。これを行うために素手で使用しないでください。次に、酢またはレモンジュースに浸した綿棒でバッテリーコンパートメントを清掃します。乾かして新しい電池を入れてください。

役に立った (778) 続きを読む

私の機械式時計は速く動きます、どうしたら良いですか? 確認済み

これは、磁界への暴露が原因である可能性があります。プロの時計職人による消磁プロセスを行うことによって解決することができます。

役に立った (753) 続きを読む

AMとPMは何の略ですか? 確認済み

AMはアンティメリディエム(Ante Meridiem)の略で、時間が正午より前であることを示します。PMはポストメリディエム(Post Meridiem)の略で、時間が正午を過ぎていることを示します。

役に立った (650) 続きを読む

「クロノグラフ」とは何ですか? 確認済み

「クロノグラフ」は文字通り「時間の作家」です。この用語は、ストップウォッチのように、時刻を表示するだけでなく、特定の期間を測定する時計や時計を表すために使用されます。

役に立った (562) 続きを読む

GMTとは何ですか? 確認済み

GMTはグリニッジ標準時の略です(UTCと呼ばれることもあり、協定世界時の略です)。ロンドン近郊のグリニッジを通過する経度0の時刻です。

役に立った (388) 続きを読む

クォーツムーブメントとは何ですか? 確認済み

クォーツムーブメントを搭載した時計や時計は、電池で駆動します。これにより、水晶振動子に電流が流れ、振動します。これらの振動はムーブメントに伝わります。振動の周波数は固定されているため、クォーツムーブメントを備えた時計や時計は非常に正確です。

役に立った (386) 続きを読む

カシオの腕時計のガラスの内側に湿気が入り込んでいます。どうすればよいですか? 確認済み

カシオは、気温が極端に変化した後に湿気が生じ、その後比較的急速に消えた場合は、おそらく何も問題はないだろうと説明しています。湿気が消えなければ、お手持ちの腕時計をできるだけ早く修理に出してください。

役に立った (55) 続きを読む
説明書 カシオ Edifice EF-527D-1AVEF 時計

関連製品

関連カテゴリ